Publicité
Les langues disponibles
Les langues disponibles
PRO III / PRO III R
*Instructions for installing the headlamp
Headlamp
Method:
•
Take the item out of the packaging
•
Open the kickstand and check that the item is stable
•
Open the handlebar stem and secure it by closing the lever of the closing mechanism
•
Connect the display power cable to the main wiring (if necessary)
•
Connect the front light to the 2-pin cable coming from the display (if necessary).
•
Install the handlebar on the stem (do not crush the cables)
•
Tighten the screws on the stem using the wrench supplied
•
Adjust the column closing mechanism
•
Check the tyre pressure (see the side of the tyre for the recommended value).
M5
1. Insert the M5 screw (without washer) into the lower hole of the light, then insert
the washer between the screw and the column and tighten it just enough to avoid
damaging the light dashboard.
M6
2. Insert the M6 screw into the upper hole of the light and tighten it.
12
Washer
Publicité
