Senix LSPG-L2 Manuel D'instructions page 8

IMPORTANT: This unit is shipped without gasoline or oil in the engine. Make sure
to service engine with gasoline and oil as instructed in the Engine
Manual before starting or running the machine.
NOTE: Reference to right and left hand side of the Lawn Mower is observed from
the operating position.
OPENING CARTON
1. Cut each corner of the carton vertically from top to bottom.
2. Remove all loose parts.
3. Remove loose packing material.
REMOVING UNIT FROM CARTON
1. Lift unit from the rear to detach it from underlying carton material and roll unit
out of carton.
2. Check carton thoroughly for any other loose parts.
Assembly parts in carton
• Bolt/Nut for mounting lower handle(Qty. 4)
• Star Knob/Bolt for mounting upper handle (Qty. 2)
• Axle Sleeve/Axle Pin/Nut for mounting wheels (Qty. 4)
• Side Discharge Cover
• Side Discharge Bolt/Nut (Qty. 2)
• Rear Trailing Shield
• Shield Holder (Qty. 2)
• Bottle of oil
• User Manual/Engine Manual
ASSEMBLY
Attach Handle
IMPORTANT: Position the handle assembly before rear wheel installation.
1. Fix the lower handle on mower deck by bolts and nuts (Figure 2).
2. Connect the upper handle to the lower handle by bolts and star knobs (Figure 3).
Attaching Four Wheels
Cutting height of three mounting holes: Top hole:1.35 inch; Middle hole: 2.3 inch;
Bottom hole: 3.15 inch. Available cutting height is from 1.35inch to 3.15inch which
is only related to wheel mounting holes. Select desired holes for wheel mounting.
1. Align the wheel with wheel mounting holes and attach the wheel to the mower.
2. Screw each wheel with axle pin,axle sleeve and nut (Figure 4).
3. Make sure four wheels are firmly locked and at a same cutting height.
IMPORTANT: To avoid unbalance, never choose different height holes for four
wheels.
8
ASSEMBLY
Figure 2
Figure 3
Figure 4
WWW.SENIXTOOLS.COM