KitchenAid W10275503B Instructions D'installation page 16

3
Mark line
Back
Measure 9²⁹⁄₃₂" (25.2 cm) from top edge and mark a line on
the back of customer-supplied custom panel. Position the
outer panel on the back of the customer-supplied custom
panel as shown, so that the top holes in the outer panel are
on the line, and both panels are centered side to side.
4
Mark pilot holes
Mark all four hole locations; remove outer panel. Drill ³⁄₃₂"
pilot holes ¹⁄₂" (13 mm) deep in customer-supplied custom
panel. Place the outer panel on the back of the customer-
supplied custom panel; align holes.
5
Attach handle
Attach outer panel to back of customer-supplied custom
panel with the four #10-16 x ³⁄₈" hex head screws supplied
in the literature package. Attach the handle. The handle
should be centered on the front of the customer-supplied
custom panel in the area shown.
IMPORTANT: Screw heads must be flush with back of
customer-supplied custom panel.
16
"
(25.2 cm)
Top edge
Mark pilot
holes
6"
(15.2 mm)
Hex Head
Screw
6
Attach body panel
Reinstall
3 screws
each side
Attach the panel assembly to the door by reinstalling the
three screws on each side; do not tighten completely. This
reinstallation of the three screws will hold the panel
assembly in place on the door frame.
7
Install custom panel
Customer-supplied
panel
Align the top edge of the customer-supplied custom
panel with the top of the console.
Drill two ³⁄₃₂" pilot holes ¹⁄₂" (13 mm) deep, into the
customer-supplied custom panel, through the holes in the
top corners on the inner panel, as shown.
8
Install custom panel
Customer-supplied
panel
Install the two #8-18 x 1³⁄₈" screws from
the literature package in the top corners of the inner
panel. Tighten the six side screws reinstalled in Step 6.
Align top
edges
Customer-supplied
panel
Align top
edges
Drill through
these holes
Align top
edges
Drill through
these holes
1³⁄₈" Screw