Publicité
Les langues disponibles
Les langues disponibles
PARTS
A. Top cover
B. Main cover
C. Upper Tray
D. Heating Plate (inside) I. Tongs
E. ON/OFF Button
F.
Cycle Start Button
TO USE
1. Before running this appliance, it is important that all bottles, bottle parts
and/or other accessories are clean. They must be washed, rinsed and empty.
2. Position the appliance on a flat surface and out of reach of children where it
cannot be knocked or moved during operation. Remove the tray.
3. Remove the measuring cup and tongs from the unit.
4. Fill the measuring cup to the FILL LINE (3 oz/80 mL) with DISTILLED WATER and
pour the water ONTO THE HEATING PLATE.
Note: For best performance, use recommended water and descale monthly.
Water with minerals may shorten the life of this appliance.
CAUTION: DO NOT EXCEED the recommended amount of water.
If it is necessary to drain water from the base, always POUR AWAY
FROM YOU.
5. Place the removable tray (part H) in the sterilizer heating chamber. Arrange the
bottles and other parts in the tray.
Note: If using Dr. Brown's bottles and parts, see Figure A through Figure G
on the next page for suggested layout options. Both narrow and wide-neck bottles
are shown.
6. Close the main cover (part B) and arrange the parts on the upper tray (part C) as
shown in Figure C and Figure G.
Note: This appliance can sterilize any item that can withstand boiling water,
such as pacifiers/soothers, teethers, toys and utensils.
7. Close top cover (part A).
8. Plug the power cord into an electrical outlet and press the On Button (E).
Note: When the sterilizer is turned on, you will notice that cycle indicator lights (G)
will illuminate with a cycle of RED-BLUE-GREEN colors. After this initial cycle-through
of colors, the green symbol will remain lit indicating "READY" mode.
G. Cycle Indicator
Lights
H. Removable Tray
J. Measuring Cup
A
B
G
E
F
J
I
C
D
H
Publicité
