POLTI Forzaspira AG100 Manuel D'instructions page 17

FORZASPIRA AG100 - AG130 - M0S10990 - 1Q09 - 2016:FEV 1000-950.qxd
USE
♦ Assemble the 28 cm window cleaning
frame. (B) or the small 17 cm window clea-
ning frame (O)*, based on the size of the
surface to be cleaned, to the base until it is
hooked (Fig. 2).
♦ Clean the window.
♦ Turn on the appliance by moving the switch
forward (E) (Fig. 3). The operating/recharge
(D) LED will turn on.
♦ Place the window cleaning frame on the up-
per part of the window and using a slight
pressure move downward (Fig. 4).
♦ Once the cleaning operation is finished,
turn off the appliance by moving the switch
backward (E).
(*) Only for Model AG130.
EMPTYING THE DIRT COLLECTION
TANK
When the Max level of dirty water is reached
in the tank (I), it must be emptied as follows:
♦ Turn the appliance off.
♦ Pull the tank stopper (H) (Fig. 5).
♦ Tilt the tank so that the dirty water can
come out (Fig. 6).
♦ Replace the tank stopper.
♦ Resume cleaning operations.
WARNING: If the maximum filling level is
exceeded, small quantities of water can
leak out of the ventilation slots. Always
empty the tank before the maximum filling
level is reached.
PROBLEM
The appliance won't turn on
All manuals and user guides at all-guides.com
FORZASPIRA AG100 - AG130
• Before performing any maintenance
• To clean the body of the appliance, simply
• The cloths provided can be washed by fol-
♦ Release the window cleaning frame and re-
♦ Rinse the frame (B) - (O)* under running
(*) Only for Model AG130.
♦ Remove the tank unit (I) (Fig.12), empty it
TROUBLESHOOTING
CAUSE
Battery discharged
ON/OFF switch (E) is turned off
15
23/09/2016
CARE OF YOUR APPLIANCE
operation, make sure that the appliance
is off and/or disconnected from the
mains.
use a moist cloth. Do not use solvents or
detergents which may harm the body mate-
rial.
lowing the instructions included on the label.
CLEANING OF THE WINDOW CLEANING
FRAME (B) - (O)*
move it from the base (Fig. 11).
water and let it dry.
CLEANING THE TANK UNIT (J)
(see paragraph "Empty water from tank").
Unscrew the tank stopper w/filter (I2) and
squeeze it (Fig. 13), after which rinse all the
components under running water and let
them dry.
SOLUTION
Charge the appliance
Turn on the ON/OFF switch (E).
14.34 Pagina 15