Sanyo VDC-DP9585P Manuel D'installation

INSTALLATION MANUAL
Color CCD Camera
THIS INSTALLATION SHOULD BE MADE BY A QUALIFIED
SERVICE PERSON AND SHOULD CONFORM TO ALL LOCAL
CODES.
Please read this manual before installing and using this unit, and always follow the instructions
in it for proper use. Please also read the separate INSTRUCTION MANUAL before using the unit
for proper use.
This unit can be installed on the ceiling or wall.
When installing, first remove the built-in camera
from the unit.
Ceiling Installed (see page 1)
(In-ceiling routing)
(Surface routing)
Wall Installed (see page 3)
(In-wall routing)
Since the conduit hole cover is not
waterproof-finished, always be sure to
seal the cover entirely by puttying, for
example, upon completion of installation.
All manuals and user guides at all-guides.com
(Surface routing)
VDC-DP9585P
Important
• Be careful when opening holes for installing
the unit. Work with the power and video
cables pulled out for easy installation.
• Make sure to properly perform waterproofing
for the ceiling or wall where you are installing
the unit.
• Make sure that the surface in the installation
location has no unevenness and is strong
enough to bear the total weight of the unit.
• Install this unit in an environment where the
temperature range stays between -10°C
and +50°C (no condensation allowed).
• As a precaution against static electricity
damage, touch a nearby metal object (door
knob, etc.) to dissipate static electricity in
your body before touching this unit.
b When routing the cables on ceiling or wall
surfaces:
Loosen the conduit hole cover fixing screw (A) on
the back of the camera unit base with the hexagonal
wrench (small), open the cover (B), and pass the
connection cables through the conduit hole.
A
B
b Replacement timing of major parts
If the unit is used continuously, parts will
become worn and deteriorated depending on
the environment of use.
It is recommended that parts be replaced
approximately every 2 years (approximately
1,200,000 times) in order to maintain unit
performance.
• Motor, cables used in mechanical parts,
gears, etc.