Kichler 39456A Mode D'emploi page 5

ASSEMBLY INSTRUCTIONS
3. Wire connection guide:
Ground wire:
• For installation in the United States: Wrap
ground wire from outlet box around ground screw on
mounting bracket (B) no less than 2 in. from wire
end. Tighten ground screw. If fixture is supplied with
a ground wire, connect to outlet ground wire with a
wire connector (AA).
• For installation in Canada: If fixture is supplied
with ground wire, wrap ground wire around ground
screw on mounting bracket (B). Tighten ground
screw. Connect fixture ground wire to outlet ground
wire with the wire connector (AA).
Supply wires:
• Connect the Neutral (White) supply wire from the
outlet box to the Neutral fixture wire (White or
Parallel Cord "D" shaped and ribbed).
• Connect the Hot (Black) supply wire from the outlet
box to the Hot fixture wire (Black or Parallel Cord
round and smooth).
NOTE:
Fixture wires will either be:
• Black and White.
• Parallel Cord SPT-1 lamp wire with one
round smooth wire and one "D" shaped
ribbed wire.
Hardware Used
Wire Connector
AA
4. Mounting surface should be clean, dry, flat and
1/4 in. larger than the canopy (A) on all sides.
Any gaps between the mounting surface and
canopy (A) exceeding 3/16 in. should be
corrected as required with silicone caulking
compound. Caulk completely around where the
back of canopy (A) meets the wall surface to
prevent water from seeping into outlet box.
3
BARE COPPER,
OR GREEN
GROUND
SUPPLY WIRE
BLACK SUPPLY
WIRE
WHITE SUPPLY
WIRE
BLACK SUPPLY
WIRE
WHITE SUPPLY
WIRE
x 3
4
5
BARE COPPER,
AA
OR GREEN
GROUND
FIXTURE
WIRE
BLACK FIXTURE
WIRE
WHITE FIXTURE
WIRE
OR
PARALLEL
FIXTURE CORD
(ROUND AND
SMOOTH)
PARALLEL FIXTURE
CORD ("D" SHAPED
AND RIDGED
A
)