Koenic KMG 4151 B Mode D'emploi page 15

Assembling and use
For all applications:
Insert the meat grinder attachment
Fig.
1
into the connection on the motor
housing by about 30 °. Turn the meat
mincer attachment to the left as far
as it will go until the release button
clicks into place and the filling opening
of the meat grinder attachment is
approximately vertical.
Put the bowl on the meat grinder
attachment.
Meat grinder (O + A/B/N)
The mid size grinding disc (5 mm) is already pre-
assembled in the meat grinder attachment.
To use other grinding discs, remove them
from the magazine on the back of the motor
housing.
Remove the union nut and remove the
Fig.
2
unwanted grinding disc.
Ensure the correct sequence and
Fig.
3
position of all parts and place the
desired grinding disc on the screw end.
Make sure the nose on the meat grinder
attachment is in the groove of the
grinding disc.
Screw the union nut back onto the
mincer attachment.
Connect the power plug to the mains.
Fig.
4
KMG4151B-Meat Grinder_190809_V06_HR.indb 15
All manuals and user guides at all-guides.com
Place a suitable container in front of
Fig.
5
the meat grinder attachment. Switch
on the device with the ON/OFF switch.
Feed meat, vegetables or other suitable
foods that are sufficiently small into
the feeding chute of the mincer. Use
the pusher as intended. If all food has
been ejected from the grinding disc,
switch off the appliance by pressing
the ON/OFF switch again. If the device
locks up or runs hard, switch it off, let
it come to a standstill and then press
the reverse button REV. If the conveyor
screw is free again, continue with your
work.
When you have finished your work,
switch off the device and disconnect
the power plug. Clean the device
immediately as given in chapter
Cleaning and care.
Sausage production (I+K)
Attention
In this application, the blade and grinding disc
must be removed.
Remove the union nut and remove the
Fig.
6
grinding disc and blade.
Attention
The blade is very sharp. Be careful when
handling the blade.
English
15
12/8/2019 10:09