ENGLISH
1
The products must be checked for visual defects, and/or scratches, prior to assembly. Once the
product has been assembled, the right for a customer to make a complaint due to visual defects
expires.
2
It is the installer´s responsibility to choose the correct fixing method.
3
Please have a qualified electrical specialist carry out the installation.
4
To dim this luminaire, please only use a reverse phase-cutting rotary dimmer. The rotary dimmer
must have a built in on/off switch and a power range starting from ≤ 20W.
5
For technical reasons, the dimmer range starts at 30% and does not use the entire rotation angle
of the dimmer.
6
Differences in brightness and white tone of the LED's are conditional of manufacturing and are no
reason for a complaint.
7
Please clean the lamp with a dry cloth. We recommend microfibre cloths for sensitive surfaces.
Only clean the lamp after it has cooled down.
8
Surface protection:
All polished, lacquered or galvanised surfaces have to be protected against all types of stresses
- especially all copper parts, as they are only provided with an invisible protection against
tarnishing.
GLOBE CEILING 12 UP
Protection class 1
This product contains a light source of energy efficiency class F. The LEDs can be replaced by the
F
producer only.
PRI 220 - 240 V / 50/60 Hz / SEC 350mA / 12W LED
73/23/EWG | 89/336/EWG
GUARANTEE:
You have purchased a high-quality product that was produced and packaged with the utmost care.
Should you nevertheless have grounds for complaint, please contact your retailer quoting the inal
inspection number as stated on the last page of this document. We will deal with your complaint im-
mediately. This warranty applies only to products that have been itted appropriately – we therefore
recommend itting by quali ied personnel.
9