Axis T95A00 Guide D'installation page 6

Page 6
Note:
Do not install the camera in the housing at this point. Transport it carefully to the place of
installation first.
Fix the dome to the housing
Place the fastening ring over the dome. Insert the four
10mm M3 screws, so you hold the ring, the dome, and
the gasket together. Fix the dome (transparent or
smoked) on the bottom of the housing.
AXIS 213 PTZ, AXIS 214 PTZ, and AXIS 215 PTZ power connection
1. Connect the (provided) power connector to the 12 VDC output as shown in the picture.
2. Connect the network camera's power cable.
Network camera power connector
AXIS T95A00/T95A10 Dome Housing output 12V DC
Camera power connector
black
red
All manuals and user guides at all-guides.com
Housing
GND
12 V
AXIS T95A00/T95A10 Dome Housing
Fastening ring
Dome
Rubber gasket
Housing
12V DC
fastening ring