Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
PD30EM & PD40EM Installation and User manual
7.
Put the connectors in the PD40EM together and place them in the
space beneath the lockcase. Be sure that the guides are matching
each other. See figure .
8.
Push the lockcase back in final position. (Possibly wait to tighten it
until the system is tested).
9.
Place the PD40EM on the outside of the door with the handle
attached, and pass the lever handle spindle through the square
hole. See photo .
Note! The red mark on the follower should always point upwards.
Feed the cable to the space at the outer side of the lockcase.
10.
Tighten, not too hard, the four previously loosened screws (the
screws for the handle first). See photo .
11.
Log on an authorised card (or tag) in Entro and test it on PD40EM.
You can that see that the unit operates correctly by seeing the yellow
LED (on the front) flashing, until five readings are performed. The
LED will then go off.
12.
Ready!
RED
13
Publicité
