Publicité
Les langues disponibles
Les langues disponibles
The operator holds the machine by the rear handle with one hand and the front handle with the
other hand. Climbing on the machine while it is running is strictly prohibited.
Floor stripping method:
1. Select and install a blade suitable for the type of floor covering in question.
2. Ensure that the motor trigger is not locked in the pushed-in position and then connect the motor
lead.
3. Press the motor trigger.
4. Push on the machine to slide the blade under the floor covering.
5. The blades sharpen themselves when in contact with the substrate. However, it is recommended
that their condition be checked before each use. This is why the blade must be changed if it is
twisted or worn excessively.
Only use ROMUS blades which are compatible with the machine.
U-shaped blades (ref. 94543) are used for flexible materials laid in strips. Flat blades (ref. 94541 and
ref. 94542) are used for tile-form and/or brittle materials, with the bevel on the floor.
To remove materials with a foam backing, use very sharp (new) blades and remove the foam during
the first round, as it will be generally impossible to remove it with the stripper if the rigid part has
already been removed.
Before changing the blade, remove the mains plug from the mains socket.
Warning! The blades are very sharp and there is a serious risk of injury. Wear cut-resistant gloves.
1. Disconnect the machine.
2. Using the wrench provided, loosen the three nuts under the
blade holder.
3. Remove the deflector and then the blade.
4. Position the new blade, making sure that it is fully inserted into
the blade holder and then the deflector.
5. Tighten the nuts using the wrench provided.
All manuals and user guides at all-guides.com
Use
Selecting/Installing/Changing the blade
Décolleuse « BS-1 » | Réf. 94525
Blade clamping nuts
14
Publicité
