Jata CA290 Instructions D'usage page 8

• The cleaning and maintenance done by users, can not be done
by children without any supervision, unless they are over 8
years and they are under supervision.
• If the power cord is damaged, it must be replaced by the
manufacturer or by its after-sales service or similar qualified
personnel in order to avoid a danger.
INSTRUCTIONS OF USE
• Open the filter holder (8) with the lip on the top right hand corner by moving it outwards and from right to left.
• Add the desired amount of coffee in the filter (9) using the spoon (10).
• Do not put too much coffee in the filter (9) and never press the coffee down. The water may overflow.
• To obtain a stronger or milder coffee, adjust the amount of coffee in the filter to taste.
• Close the filter holder again.
• Lift the lid of the tank (6) and pour cold water into it according to the number of coffee cups you are preparing.
The marks of the water level (7) will give you an estimated quantity.
• Close the lid of the tank, place the jug on the hot plate (3) and plug the machine into the mains.
• It is advisable to slant the jar when placing on the heating plate and when removing it.
• Set the switch (2).
• The coffee will begin to flow in a short time.
• While the coffee is being made you may remove the jug (4), as the automatic anti-drip system stops it from
dripping. Take care not to remove it for too long as the coffee in the filter holder may overflow.
• If you wish to keep the coffee hot, leave the jug (4) on the hot plate (3) and keep the coffee machine on (check
bellow ATTENTION chapter).
ATTENTION
The coffee maker will switch off automatically after around 40 minutes from its operation, to comply with
Directive 2009/125/EC of the European Parliament.
MAINTENANCE AND CLEANING
• Before anything, make sure the coffee maker is unplugged from the mains.
• The jug, the filter and the filter holder may be cleaned with a hot soapy water taking care to rinse them
carefully afterwards.
• To remove the filter holder (8) open it completely, lift it and remove it.
• The hot plate and the body of the coffee maker should be cleaned with a soft cloth dampened in water.
• Do not use abrasive or chemical products, such as metallic scourers, which may deteriorate the surfaces of
the appliance.
• To eliminate the alkaline deposits that with use may be formed in the water circuit, it is convenient to treat
it as follows:
- Pour a 50% solution of water and vinegar in the tank.
- Plug the coffee maker without any coffee and allow to flow out the half solution.
- Switch off the coffee maker and wait for 15 minutes.
- Switch on the coffee maker again and leave to flow out all the solution.
- Next, make the coffee maker work only with water for a couple of times.
ENVIRONMENT PROTECTION
• Dispose the appliance according to the local garbage regulations.
• Never throw it away to the rubbish. So you will help to the improvement of the environment.
8