Publicité
Les langues disponibles
Les langues disponibles
security
3.8
Remote-control setup
The TWIN allows the independent set-up for each of 2 channels;
memorize a different code on each button, and a channel to select (A, or B) also if they
are not on the same code.
The set-up operation has to be repeated for each of the 2 buttons of the radio-
control.
In order to start the set-up phase you have to push both the buttons for some
seconds
, until the LED remains on, then you have to leave them:
For insert the code you have to access with digit the following sequence: "1" - "1" - "0" - "0"
For insert the 10 digit of the code use:
"0" (right button ): It means dip-switch "OFF" for the previous TWIN
versions*
"1" (left button): It means dip-switch "ON" for the previous TWIN
versions*
During the insert of each code the LED will switch off for some seconds.
For insert the
Channel A
Channel B
Push the button that you want to assign at the code.
The LED switch off at the end of the set-up.
*
For example, to setup a new code or duplicate a TWIN of previous version that has dip-switch setted as below:
You have to digit the following buttons sequence:
1
1
0
0
Access
1
1
0
0
Access
For read the code you have to digit
In order to start the set-up phase you have to push both the buttons for some
seconds uring the set-up, if you don't push on any button for at least 5 seconds
, d
the LED switch off and the setting phase finish automatically. the following
sequence:"1" - "0" - "1" -"0"
Push on the button that you want to know the code (A or B)
The LED switch off and it start one series of 12 flashes:
A brief flash means
A long flash means
Unscrew the screw on the bottom of the radio-control to open the plastic cover, take off the old battery
and insert a new one according with the polarities indicated on the plastic cover.
Check the correct operation of the two buttons after to close the plastic cover.
All manuals and user guides at all-guides.com
2 digit of the channel use:
"1" - "0": It means the left button for the previous TWIN versions
"1" - "1": It means the right button for the previous TWIN versions
1
2
ON
OFF
1
0
0
1
1
0
1
code
1
0
0
1
1
0
1
code
"0"
"1"
3
4
5
6
7
8
9
0
0
1
1
0
(fast flash of the LED)
channel A
0
0
1
1
0
(fast flash of the LED)
channel B
It's possible to
10
assigned to left button
assigned to left button
Setup
1
0
31
Publicité
