Publicité
IMPORTANT SAFETY PRECAUTIONS
•
The system should only be cleaned as directed in the Fluence's Fixture
Cleaning Recommendations which can be downloaded from the Fluence
Support Center https://fluence-led.com/support-center/.
•
You should seek service for your system by qualified service personnel if any
of the following occur:
1 . The power-supply cord or the plug has been damaged .
2 . The unit has been exposed to rain .
3 . The unit exhibits a marked change in performance .
4 . The unit has been dropped, or its enclosure or chassis is damaged .
CULTIVATION BEST PRACTICES
Fluence encourages everyone to experiment and pursue their own techniques .
Every crop is different and everyone has different goals . However, our internal
research has given us insight into several strategies we would like to share .
•
Regularly check your plants' growth and health . Fluence lighting systems
deliver high levels of PAR, typically more than experienced in nature .
Adjustments to H2O, CO2, RH, nutrients, and temperature are typically required .
•
Mount the fixture at least 6" from the top of your canopy to ensure optimal
uniformity and consistent PPFD . The SPYDR Series was designed to provide
uniform light dispersion and requires precise deployment . A 1" variation in
either direction will have a significant change in uniformity and PPFD (which
may or may not be desired) .
•
Many plants prefer higher temperatures when exposed to high PPFD .
Experiment with higher temperatures to achieve higher yields . Canopy
temperature and room ambient temperature often vary . For accurate results,
test at the canopy level to gauge leaf surface temperature .
•
Fluence recommends the use of AC circuit contactors to completely
disconnect the facility AC voltage from the luminaire to mitigate potential
glowing or dimming interruptions of the crop dark period . For more
2
information, please download the Dim-to-Off Application Note available at
the Fluence Support Center https://fluence-led .com/support-center/ .
For cultivation recommendations visit
https://fluence-led.com/science-articles/.
GENERAL CARE
SPYDR 2 system is passively cooled with zero moving components . They are
designed for harsh environments and years of maintenance-free performance .
Some basic care will keep your system operating at peak performance cycle-
after-cycle .
•
Natural convection removes heat away from the heatsink . In order for
the system to properly cool itself, at least one inch of space is required
between the console and the roof of your grow area . Failure to do so may
shorten the fixture's lifespan .
•
To achieve the optimal lifespan and performance of your fixtures, routinely
check for and remove excess dust, debris, and mineral build up from
heatsink and LED array . Cleaning should always be done with the fixture
unplugged from its power source using low-pressure compressed air or
water to rinse away dirt from light bars .
•
Never use a cloth to clean the diode array . Doing so can scratch or
compromise the integrity of the silicon seal, or dislodge diodes entirely .
•
To limit degradation, avoid touching the diodes with your hands, even in a
powered off state .
For detailed instructions for maintenance and cleaning,
please visit
https://fluence-led.com/support-center/.
SPYDR 2 is a high-performance lighting system.
Do not touch while in operation.
PLEASE RECYCLE ALL PACKAGING MATERIAL
Publicité
