Jata BT797 Instructions D'usage page 10

• Do not remove the jug with the food until the blade is totally
stopped and the appliance has been switched off.
• Make sure neither the appliance nor the cable are in direct
contact with hot surfaces or objects.
• Always place it on a flat surface.
• Always disconnect it from the mains when you do not use it
and before assembling / disassembling or when cleaning.
• There are risks of injury in case of improper use. You must
be careful when handling the cutting blades, when the jug is
empty and during the cleaning.
• High temperature contrasts could be the cause of broken jars,
avoid them to prolong the life of your glass jar.
• The cleaning and maintenance done by users, can not be done
by children.
• If the power cord is damaged, it must be replaced by the
manufacturer or by its after-sales service or similar qualified
personnel in order to avoid a danger.
INSTRUCTION OF USE
• Remove the threaded base (6) -blade (7) assembly from inside the jug (3).
• Pour the food in the jug and place the lid on it. Make sure the blender is perfectly closed and maintain always
held while in use.
• Fit it correctly in the main body (4).
• Plug the appliance into the mains.
• Turn the speed selector (5) clockwise to the desired position (1 or 2). The blender will begin to work maintaining
the selected speed.
• It is advisable to begin at the lowest speed of the blender (position 1) to later raise the highest speed (position
2) if necessary. However, and depending on the texture of the food, you may use the highest speed from the
beginning.
• The "PULSE" position of the speed selector gives you the option to use the blender intermittently, as it will only
work while you keep the selector (5) turned to that position, and it will stop when it is released.
• This position is ideal for crushing ice. Repeatedly hold and release the selector (5) in short periods of approximately
2 seconds to get crushed ice. For it, we suggest to use little ice cubes, or you can bitted them before put them on
the blender, to avoid the "igloo" effect. This means that the crushed ice get adhered to the blender walls, and it
impede that the other ice cubes arrive to the base to be crushed.
• You may add ingredients to the jug while in use without open the lid. To do so, remove the stopper (1). Add the
ingredients into the jug and place again the stopper.
• Once you have finished, set the speed selector to its "0" position and wait for the blade to stop turning completely
before removing the jug.
10