Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Prontopress-2
Instruction Manual
1.
Installation
1.1
Packing List
1 Prontopress-2
1 Tube spanner for fixing bolts, width 13 mm
1 Allen key 5 mm for oil screw, fig. 2.9, and draining screw.
2 Spanners for securing the lower ram (19 and 22 mm)
1 Bayonet closure (fig. 1.12)
1 Funnel
1 Measuring spoon
1 Water hose
1 Filter fitting
1 Fitting
1 Transmission fitting
1 Hose for water outlet (1,5 m)
1 Hose for connecting water from base unit to embedding unit (0.65 m)
5 Hose clips
1 Fuse
3 Resin samples (resin 3, resin 5 and resin 6)
1 Mould Release Wax
1.1.1
Packing List for Mounting Cylinder (Accessory)
The easily exchangeable cylinders come in the following sizes: 25, 30 and 40
mm and 1", 1¼" and 1½" inside diameter. Apart from the cylinders the case
further contains:
1 Lower ram
1 Upper ram
1 Syringe with heat conductive paste
Before First Time Use of the Press
1.2
The transit screw on the rear plate of the press mentioned in the text under
"See manual" must be unscrewed before using the press. Under the screw in
the fitting situated in the rear plate is placed a piece of felt (meant) for
purifying the air intake in the press. When the press is working the hydraulic
oil gets hot and it should be possible for it to expand without causing an
excess pressure in the press.
Keep the screw for later user when moving the press from the premisses. Do
not mount another screw with head or the like.
(Installation)
5
Publicité
Table des Matières
