Publicité
Les langues disponibles
Les langues disponibles
Electric fireplace Use instructions
8. Place the front glass panel over the front of the fireplace carefully aligning the hooks with the brackets on each
side of the glass panel (Fig. G)
Note: use at least two people to carry out this operation, to avoid the accidental fall and breakage of the
panel.
To firmly secure the glass panel, fasten the screws removed before on each side of the panel until com-
pletely tightened.
Operation and use
After completing installation and mounting operations, plug the appliance to the wall socket.
The appliance has a digital display that shows all the selected settings (Fig. H)
The appliance can be operated by the control panel (found on the top part of the appliance – Fig. I) or by the
remote control.
Turning on the appliance
After plugging the appliance to a wall socket, place the general switch found right below the control panel on "I".
Press
on the control panel or the remote control, the appliance will turn on and the LED flame will light up; it
is now possible to set and/or select the desired function.
To turn the appliance off, press
Day/time setting
Day/time setting can be made by the control panel, by pressing
"HOUR" and "MIN".
To set the day
From control panel: press
– Sunday; "Mon" – Monday; "Tue" – Tuesday; "Wed" – Wednesday; "Thu" – Thursday; "Fri" – Friday; "Sat" – Sa-
turday). Press "+"/"-" to select the present day of the week.
When the LED indicator related to the selected day stops blinking, the setting is confirmed
From remote control: press "DAY", display will show the LED indicator related to the selected day of the week
(see above). Press "+"/"-" to select the present day of the week.
When the LED indicator related to the selected day stops blinking, the setting is confirmed
To set the time
From control panel: press
to set the hour (from 00 to 23)
Press
three times, LED indicator related to the minutes on the display will start blinking. Press "+"/"-" to set
the minutes (from 00 to 59)
When the LED indicator related to the selected hour/minutes stops blinking, the setting is confirmed
From remote control: press "HOUR", LED indicator related to the hour on the display will start blinking. Press
"+"/"-" to set the hour (from 00 to 23)
Press "MIN", LED indicator related to the minutes on the display will start blinking. Press "+"/"-" to set the minutes
(from 00 to 59)
When the LED indicator related to the selected hour/minutes stops blinking, the setting is confirmed
Flame intensity adjustment
The intensity of the flame can be regulated from the control panel, or from the remote control, simply by pres-
sing
until the desired level of intensity is selected.
5 levels of intensity are available, from the highest to the lowest.
Selection is shown on display.
Heating mode setting
Heating mode can be set both from control panel and remote control.
To set heating mode from control panel, press
Press once to select low heating mode
Press twice to select high heating mode
Press three times to turn heating off; the fan will keep operating for approx. 10 seconds before coming to a
complete stop
All manuals and user guides at all-guides.com
again.
, display will show the LED indicator related to the selected day of the week (Sun"
twice, LED indicator related to the hour on the display will start blinking. Press "+"/"-"
as follows:
, or by the remote control, by pressing "DAY",
18
Publicité
