Zumtobel EPURIA-S Mode D'emploi page 5

Parametrization of the luminaire
All parameters, like constant light control, etc. can be changed using ILD Gen 2 FSL programmer (not
supplied with the luminaire). Caution: Parametrization is only possible for luminaires with sensor (SC)!
IR 6+ remote control
Article number: 28000647
Target Group: end user
Questions about EPURIA-S
For questions about EPURIA-S Lighting Management, please contact:
Zumtobel Lighting GmbH
Schweizerstrasse 30
6850 DORNBIRN
ÖSTERREICH / AUSTRIA
For general information about our products, please refer to our website,
www.zumtobel.com or contact the respective contract partner. If you have any special
questions, please contact your sales partner.
EPURIA-S FAQ
►Motion sensor does not function
→ Dim value set too low, luminaire switches
off
→ Brightness in the room too high, luminaire
switches off (Bright out active)
►Luminaire switches itself on
→ Lighting level in the room is below the
set brightness value
→ Motion sensor reacts to detected motion
in the room
→ Motion sensor reacts to a fast change of
heat in the room (for example, as well
as persons, printers, radiators etc. can
also be detected as motion)
00157562/PA/AR/03/2023
ILD Gen 2 FSL programmer
Article number: 28000257
Target group: electrician, facility
manager
►Luminaire does not switch on
→ Check plugs for supply of the luminaire
→ Check mains adapter of the luminaire
→ Luminaire or EPURIA-S Lighting
►Setting of the dim value
→ Do not influence or cover the light sensor
►Light sensor does not function
→
Management defective
when setting the target value
Automatic mode deactivated
4 EN