Publicité
Les langues disponibles
Les langues disponibles
management
Operation via switch for luminaire version LST & SC
The operation of the luminaire is performed by a switch in the luminaire.
The SC version can be additionally operated and parametrized using a remote control (see page 2)
For luminaires with integrated basicDIM wireless no manual operation is possible!
Operation
Switch on luminaire
Switch off luminaire (standby)
Adjust illuminance manually (dim)
Set light level
Functions of EPURIA with daylight and presence detection (SC)
The functions of the EPURIA Lighting Management guarantee high comfort at the workplace and can
significantly reduce the energy consumption.
Constant light regulation
decreased. In doing so, the adjustment is performed with a certain inertia to prevent too fast and thus
unpleasant change of the illuminance.
A desired light level (incl. OFF) can also be set manually via the push buttons on the IR6+ remote control (not
supplied with the luminaire): Dimming the luminaire up by long pressing
long pressing
Switch the luminaire on by pressing
between on/off of the direct or indirect light only by pressing
control. This level is maintained as long as presence is detected. After 10 minutes of absence the automatic
mode is re-enabled. Constant light regulation is activated by default, to set the actual light level as the target
value for the constant light control, press
with the
on the ILD Gen 2 FSL programmer (not supplied with the luminaire).
Motion detection
To deactivate the motion detection press
00157562/PA/AR/03/2023
Briefly press switch once
Briefly press switch once
Press and hold switch until the desired illuminance level is set. To change the direction
of the adjustment, release the switch, press again and keep pressed.
Choose desired illuminance level – briefly press switch twice – luminaire flashes for
confirmation. After Standby / power failure (only if "Power-Up" is turned ON – default)
the luminaire switches back in to this set light level. (SC luminaire only)
The constant light control of the EPURIA Lighting Management
automatically adapts the lighting to the lighting conditions at the
workplace (sunshine, overcast sky, closed Venetian blinds).
A brightness sensor compares the illuminance on the work
area with an adjustable desired value. If the illuminance is
below the desired value, the luminaire output is
automatically increased. If the illuminance on the work area
is above the desired value, the luminaire output is automatically
for >3 seconds. Constant light regulation can be deactivated
The luminaire is switched on and off automatically using the
motion detection. A passive infra-red sensor (PIR) monitors the
detection range for this (diameter approx. 3.2 m). The luminaire is
switched on automatically as soon as any person is located in the
detection range. However, if the constant light control registers
illuminance above the individually adjustable desired value, the
luminaire remains in standby mode. If no person is registered in
the detection range within an adjustable run-on time the luminaire
automatically switches to the standby mode.
on the ILD Gen 2 FSL Porgrammer (not supplied with the luminaire).
. Dimming the luminaire down by
Switch the luminaire off by pressing
in the group section of the user remote
Toggle
2 EN
Publicité
