Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
English
shell of the seat. The press studs of the
seat cover can now be attached to the
press studs of the side support. (t2)
· ! Make sure that the canopy is properly
attached to the velcro at the top of the
backrest.
Attach and remove bumper bar (u)
· Push the ends of the bumper bar in the
thereto designated notches in the seat
until you hear a click.
· Press the unlock buttons on both sides
of the bumper bar and remove the bum-
per bar from the seat.
The integrated foot step (w)
· There is a zipper around the leg support
of the seat. If so desired you can open
this zipper to thus create a higher foot
rest for your child. The child can then
place the feet on the aluminium bar of
the leg support. When you child gets
bigger you can again close the zipper
and your child can place the feet on the
plastic foot rest of the frame.
The hood (v1, v2)
· Hold the front hood bar in the centre
and move it forwards or rearwards to
adjust the hood. (u1)
· Open the zipper in the centre to further
enlarge the hood. Close the zipper to
again reduce the hood. (u2)
· Pull the flap on the front side of the
hood outwards to additionally enlarge
the hood. Push the flap inwards to
again reduce the hood.
Assemble the rain cover on the seat (x)
· Make sure that the hood of the seat is
in the upright position.
· Possibly open the zipper in the rain
cover to adapt it to the enlarged hood
of the seat.
· Place the rain cover from top to bottom
16
over the seat and make sure that the
rain cover is attached well behind the
back support and over the leg support.
The 5-point safety harness (y1,y2)
· Place your child in the seat and make
sure that the legs of your child are
placed on each side of the leg piece.
· Make sure that the hip and shoulder
belt is positioned correctly over your
child and place both plastic clamps in
the central part of the harness attached
to the leg piece.
· To adjust the length of the shoulder
straps, loosen the shoulder protectors
from the belt by undoing the snap but-
tons. This will reveal the belt buckles.
Adjust the length by sliding the buckles
along both shoulder straps until your
child is comfortably secure. After ad-
justing, press down both snap buttons to
relock the shoulder protectors in place.
· The back support contains three posi-
tions for the shoulder belts. To adjust
the position you remove both shoulder
belts by moving the attachment rings
through the openings in the back of the
seat. Move the attachment rings through
the desired openings so that the shoul-
der belts are positioned properly.
· Regularly check the length and position
of the belts and adjust, where necessary.
The Graco car seat (option)
· The Graco car seat adapter is suitable
for use with the Graco Snugride Classic
Connect, Snugride 30 Classic Connect
and Snugride 35 Classic Connect: 5-22
lbs. <29 in. (2,2-10 kg, <74 cm) and
the Graco Safe Seat: 5-30 lbs. <32 in.
(2,2-13 kg, <81 cm).
· Always observe the instructions in the
manual of your Graco car seat before
you start using the car seat.
· Make sure that the frame has fully been
Publicité
