Publicité
Les langues disponibles
Les langues disponibles
4.4.1 Awnings prior to 03/2007
− Awnings prior to 03/2007 use a different principle for attaching the bottom plate,
therefore some additional measures are required:
•
Remove the clamping bracket and screw from the bearing supports and the cover
supports and remove the bottom plate (fig. 1.4 et fig. 1.5).
•
Shorten the prong of the bearing supports and cover supports (fig. 1.6).
Fig. 1.4
4.5. Install the power supply
− Place the holder with the power supply and the adjusted clamps on the torque bar on
the operating side (fig. 2.1).
− Together with the clamps, tighten the holder using M5 x 70 screws (fig. 2.2).
Fig. 2.1
4.6. If RTS, IO (option 2 to 4)
− Remove the old pulley plate on the operating side. (fig. 3.1).
Fig. 3.1
− Position the new pulley plate with receiver (fig. 3.2).
Fig. 3.2
Fig. 1.5
Fig. 2.2
LED LX530
Fig. 1.6
05/2014 | 13
Publicité
