Defiant DF-5311-BZ-D Guide D'utilisation Et D'entretien page 7

Installation (continued)
Caulking Around the Light
5
Fixture
Caulk around the canopy (B) and mounting
surface with silicone sealant (not included).
Installing and Replacing the
6
Bulb
CAUTION: Burn hazard. Allow the light fixture and the
bulb to cool before touching.
NOTICE: Use two hands when removing the glass cover. The glass
cover is only being held in place by the glass retaining clips.
NOTE: The bulb is included, but needs to be installed. The
bulb is located behind the glass cover of the lamp head.
Use a clean glove or cloth when handling the new
bulb. Use isopropyl (rubbing) alchohol to clean the bulb
if it is touched with bare hands.
While holding the glass cover (6) with one
hand, unlatch the glass retaining clips (5).
Remove the glass cover (6).
Remove the bulb (GG) from the box.
Place one end of the bulb (GG) on the contact
in the right bulb socket (7). While pushing the
bulb (GG) against the contact, lower the other
end of the bulb (GG) onto the contact in the
left bulb socket (8). The bulb (GG) should spin
easily if it is seated properly.
Make sure the gasket (9) is seated properly
in the groove around the edge of the bulb
holder (A). Center the glass cover (6) on the
bulb holder (A) and secure using the retaining
clips (5).
To remove the bulb (GG), push the bulb (GG) to
the right until the left side of the bulb (GG) is
clear of the left bulb socket (8).
9
5
2
8
6
7
Please contact 1-866-308-3976 for further assistance.
B
A
1
5
7
GG
HOMEDEPOT.com