Summit Treestands FBFAHS Mode D'emploi page 5

ATTACHING THE TETHER STRAP TO THE FULL BODY HARNESS & TO THE TREE.
WARNING
!
NEVER be disconnected from the tree once you leave the
ground until you return safely back to the ground!!
WARNING
!
When attaching the Tether Strap to the tree, be sure
the free end is fed completely through the tether
loop on the Full Body Harness as shown in figure 11.
ALWAYS ADJUST THE TETHER STRAP TO MINIMIZE
THE SLACK WHILE YOU ARE CLIMBING.
1. Insert the Tether Strap end into the sewn looped end of
the Full Body Harness tether figure 11. Hold the Tether Strap
buckle in one hand and loop the free end completely around
the tree. See figure 12.
2. Thread the free end into the buckle as shown in figure 13
(Buckle Threading Diagram) and figure 14. The strap end
should be brought into the back-side of the buckle.
3. Loop the free end of the Tether Strap over the knurled
metal post on the buckle and route it out the backside as
shown in figure 13 and 15.
WARNING
!
ALWAYS confirm the Tether Strap buckle has been
threaded properly before each use.
4. Orient buckle 90 degrees from tether connection. Pull the
free end snug and cinch down. See figure 16.
14
WARNING
!
ALWAYS confirm that the Tether Strap does not slip
when pulling on tether on Full Body Harness! DO NOT
USE if the Tether Strap slips through the buckle!
All manuals and user guides at all-guides.com
11
BUCKLE
13
DO NOT USE unless the Tether Strap has at least 5"
of free end strap remaining after you have secured
the Tether Strap to the tree!
15
12
SEWN TETHER
LOOP
Buckle
TREE
TREE
BUCKLE THREADING DIAGRAM
WARNING
!
16
Free End
5" of Strap
Remaining
MINIMUM!
PG 5