Publicité
Les langues disponibles
Les langues disponibles
en-US
Problem
The vacuum cleaner
does not start when it is
switched on.
The operating noise is
changing during vacu-
uming.
The Electrobrush
switches itself off.
The vacuum cleaner
keeps falling over.
186
Possible cause and solution
There is no battery inserted or the battery is inserted
incorrectly.
Insert the battery or check how the battery is posi-
tioned (see "Installation and connection" – "Insert-
ing the battery").
The rechargeable battery is not sufficiently charged.
Charge the battery exactly as described in these
operating instructions (see "Installation and con-
nection" – "General battery information" and
"Charging the battery").
An original Miele battery has not been inserted.
Insert an original Miele AP01/AP02/AP03 lithium-
ion rechargeable battery (HX LA).
The battery was not placed in the PowerUnit when
charging it for the first time.
To activate the battery, it must be placed in the
PowerUnit the first time it is charged (see "Installa-
tion and connection" – "General battery informa-
tion" and "Charging the battery").
The charger is still plugged in.
Pull the plug out of the charging socket on the bot-
tom of the battery.
The Electrobrush power consumption is automati-
cally set to the optimum level based on the type of
flooring and roller brush used.
The noise is not unusual – the vacuum cleaner is
functioning normally.
The Electrobrush is overloaded – this can happen on
surfaces like deep-pile carpet.
Switch the vacuum cleaner off and switch it on
again at a reduced suction power level. Use the
On/Off switch on the Comfort handle to do this.
You have configured the vacuum cleaner with the
PowerUnit at the top.
Reassemble the vacuum cleaner so that it is con-
figured with the PowerUnit at the bottom (see "In-
stallation and connection" – "Assembling the vac-
uum cleaner").
Publicité
