8.0 operation (millivolt)
operation (electronic)
EN
WARNING
!
•
If you do not follow these instructions exactly, a fi re or explosion may result causing property damage, personal
injury, or loss of life.
•
If applicable, always light the pilot whether for the fi rst time or if the gas supply has run out with the glass door
opened or removed.
Ensure that a continuous gas fl ow is at the burner before installing the door. When lit for the fi rst time, the appliance
will emit an odor for a few hours. This is a normal temporary condition caused by the "burn-in" of paints and
lubricants used in the manufacturing process and will not occur again. After extended periods of non-operation
such as following a vacation or a warm weather season, the appliance may emit a slight odor for a few hours. This
is caused by dust particles in the heat exchanger burning off. In both cases, open a window to suffi ciently ventilate
the room.
For vent free appliances ONLY: if the appliance shuts off, do not relight until you provide fresh air. If appliance
keeps shutting off, have it serviced. Keep burner and control compartment clean.
•
Do not turn on if children or other at risk individuals are near the appliance.
•
This appliance is equipped with a pilot which must be lit by hand while following these instructions exactly.
•
Before operating, smell all around the appliance area for gas and next to the fl oor because some gas is heavier
than air and will settle on the fl oor.
•
Use only your hand to turn the gas control knob. Never use tools. If the knob will not turn by hand, do not try
to repair it. Call a qualifi ed service technician. Force or attempted repair may result in a fi re or explosion.
•
Do not use this appliance if any part has been under water. Immediately call a qualifi ed service technician
to inspect the appliance and replace any part of the control system and any gas control which has been
underwater.
•
Turn off all gas to the appliance.
•
Open windows.
•
Do not try to light any appliance.
•
Do not touch any electric switch; do not use
any phone in your building
note:
When lighting and re-lighting, the gas knob cannot be turned from pilot to off unless the knob is
depressed.
A. Stop! Read the above safety information on this label.
B. Remove batteries from the transmitter and set thermostat to lowest setting, if equipped.
C. Turn off all electrical power to the appliance.
D. Open the glass door, if equipped.
E. Turn the gas knob clockwise
F.
Wait fi ve (5) minutes to clear out any gas. If you smell gas including near the fl oor, STOP!
Follow the instructions above in the "WHAT TO DO IF YOU SMELL GAS" section. If you
don't smell gas; close the glass door and go to the next step.
G. If the appliance is equipped with fl ame adjustment valve turn clockwise
H. Turn gas knob counter-clockwise
with an "ON/OFF" switch, ensure it is in the "ON" position.
I.
Depress and hold gas knob while lighting the pilot with the push button ignitor. Keep knob
fully depressed for one minute, then release. If pilot does not continue to burn, repeat steps
E through I.
J. With pilot lit, turn gas knob counter-clockwise
K. If equipped with the fl ame adjustment valve, push and turn the knob to high.
L. Turn on all electrical power to the appliance and re-install the batteries into the transmitter, if
equipped. Set thermostat to desired setting, if equipped.
A. Set thermostat to desired setting, if equipped.
B. Turn off all electrical power to the appliance if service is to be performed.
C. Push in gas knob slightly and turn clockwise
48
W415-2835 / C / 03.07.22
FOR YOUR SAFETY READ BEFORE LIGHTING
WHAT TO DO IF YOU SMELL GAS
LIGHTING INSTRUCTIONS
to the "OFF" position.
to the "PILOT" position. (If the appliance is equipped
to the "ON" position.
TO TURN OFF GAS
to the "OFF" position. Do not force.
•
Immediately call your gas supplier from a
neighbour's phone. Follow the gas supplier's
instructions.
•
If you cannot reach your gas supplier, call
the fi re department.
to "OFF".
31.1A
add gas knob
add gas valve