BorMann PRO BHL5710 Mode D'emploi page 6

EN
Operation
To open the ladder to intermediate length
Place the Telescopic Ladder on a firm, level surface.
Place your foot on the Bottom Rung (6) to stabilise the Ladder.
When each step is fully extended, you should hear a "click",
confirming that the Locking Mechanisms (3) are engaged for that
level.
To open the ladder to full length
Place the Telescopic Ladder on a firm, level surface.
Place your foot on the Bottom Rung (6) to stabilise
the Ladder.
6
Starting with the second rung from the bottom, use both hands to grasp
the Hand Grips (4) on either side of the rung and pull upwards to extend
the step.
Closing the ladder
Hold the Telescopic Ladder in an upright position.
Place one foot on the Bottom Rung (6) to stabilise the Ladder.
Starting at the lowest extended rung, use both hands to grasp the Hand Grips (4) on either side
of the rung, then, with your thumbs, disengage the Locking Mechanisms (3).
Starting with the Top Bar (1), use both hands to
grasp the Hand Grips (4) on either side of the
rung and pull upwards to extend the step.
WWW.NIKOLAOUTOOLS.GR
When each step is fully extended, you should hear
a click", confirming that the Locking Mechanisms (3) are "
engaged for that level.
IMPORTANT: If you are opening the Ladder to its
full length, you should always extend from top to
bottom.