Bowers & Wilkins Pi7 S2 Mode D'emploi page 6

7.1 Controlling Your Earbuds
Commonly used features of your earbuds are
accessible directly on the Music app home page:
• Battery status
• Environmental controls (Noise Cancellation/
Pass-Through)
• Connected device status (refer to the
Connections section below for further details)
7.1.1 Earbud Settings Page
Other settings can be adjusted from the Settings
page. Tap the icon at the bottom of the screen to
enter the Settings page, then select your earbuds
from the list.
Environmental Controls
Set the desired noise cancelling mode from the
following options:
• Noise Cancelling On
• Auto (Adaptive) Noise Cancelling On
• Noise Cancelling Off
Set the desired pass-through mode from the
following options:
• Pass-Through On/Off
• Pass-Through Level
Connections
The two most recently connected Bluetooth
devices are shown in the Connections shortcut
buttons. The buttons will appear grey if not currently
connected. Tap the buttons to attempt reconnection.
Tap the CONNECTIONS heading to view more
detailed connection settings, including previously
connected devices (Pi7 S2 will remember up to four
devices).
Once in the Connections page, swipe a device left to
delete it from the list. Swipe a device right to make it
the preferred device to connect to when the earbuds
are switched on.
Toggle Auto-connect to last device to prompt
the earbuds to connect to the previously connected
device when they are switched on.
Device Management
Toggle Wear sensor on to enable intelligent
playback control. Once enabled, remove an earbud
to pause playback; place the earbud back in your
ear to resume playback.
Rename product
Tap Rename product to choose a new Bluetooth
name for your earbuds. Note that devices already
paired with the earbuds may still reference the
previous name.
7.2 Earbud Software Update
Bowers & Wilkins will occasionally make available
software updates that refine and optimise the
performance of your earbuds or add new features.
The Bowers & Wilkins Music app will notify you
when a software update is available. To update, tap
the notification and follow the in-app instructions.
8. Wearing Your Earbuds
Correctly wearing your earbuds will help ensure the
best possible experience. Like many in-ear earbuds,
Pi7 S2 are designed to seal the ear canal in order
to perform optimally. Ear tips come in three sizes:
small, medium and large. Finding the proper size
for your ear is critical to obtaining a good seal and
ensuring Pi7 S2, and the advanced features, such as
Adaptive Noise Cancellation, perform optimally.
1. Identify the left and right earbud by finding the
L and R identification (located on the inner side
of each earbud).
2. Place each earbud in your ear and twist them
backward slightly so that the tips engage
comfortably with the opening of the ear canal.
3. If the earbud tip feels too large or small, try
another ear tip size to ensure the best fit.
Note: To optimise call quality, ensure the
microphones, located underneath each earbud,
are not obstructed. See Diagram 6.
Diagram 6
Wearing your earbuds
Diagram 7
Streaming media
9. Media Streaming Using The Smart
Charging Case
The charging case of your Pi7 S2 can be used
to wirelessly retransmit audio to your earbuds or
another pair of Bowers & Wilkins headphones using
the supplied USB type-C-to-3.5 mm or USB type-C-
to-C cable. See Diagram 7.
1. Connect the supplied cable to the case and the
source device.
2. Your Pi7 S2 will automatically start streaming.
Note: If using Mac and streaming for the first
time, go to Apple Menu > System Preferences
> Sound > Output and select "Bowers & Wilkins
Pi7 S2".
6