oneConcept V-12 Mode D'emploi page 35

Programming titles in a specific order
This function allows you to play music tracks in a programmed order.
Note: The programme can only be set in STOP mode.
1. Press the PROG key once. Both the program number [01] and [PROG]
blink on the display.
2. Press the /
indicator blinks to prompt you to confirm.
3. Press the PROG key again to save the selection. The program number
jumps to [02] and blinks with the [PROG] indicator.
4. Press the /
[PROG] indicator blinks to prompt you to confirm.
5. Press the PROG key again to save your second selection. Repeat steps 2-4
to program up to 20 titles. Once you have saved the 20th title, the display
automatically shows the programmed titles in the order you entered them.
At the end of program viewing, both the program number [01] and [PROG]
blink on the display.
6. Press the PLAY / PAUSE key to finish and start the programmed sequence.
7. Press the key to go directly to other titles while the program is playing.
Press twice to return to a previous title.
8. You can use REPEAT / SHUFFLE to play a specific title (Repeat 1) or all the
titles in the programme (Repeat All) repeatedly.
• The player stops when all programmed titles have been played through
once. To repeat programme playback, press the PROG key followed by the
PLAY / PAUSE key.
• To cancel the programme playback, press the STOP key twice while the
programme is playing or open the CD door in stop mode.
• Press the ALBUM key to select the album. Press the MODE key to change
the audio source.
• To switch off the player, press the STANDBY key. The display backlight
goes out.
key to select the title to be programmed. The [PROG]
key to select the next title to be programmed. The
EN
35