Connecting to a Gas Cartridge
•
If the torch is fitted to an empty cartridge, then please
read "Removing Cartridge".
•
This torch is fitted with a sealing washer. Check the
sealing washer is present and in good condition before
connecting the cartridge.
•
Do not use if the seal is damaged or worn.
•
Do not use appliances that are leaking, damaged or do
not function properly.
•
Only change gas cartridges outdoors or in well-ventilated
places away from naked flames, any other ignition source
and other people.
•
Close the control valve by turning the knob clockwise (OFF).
•
Screw out the cartridge cover anticlockwise; attach the gas cartridge and screw in the cartridge cover
clockwise.
•
Slowly open the control knob anticlockwise (ON) and hold
a lighted match near the burner.
•
If the burner does not light after 5 seconds, turn off gas
valve and wait 10 seconds before re-lighting.
•
If unit does not light after several attempts, contact your
retailer.
•
Avoid moving the torch once lit because this could be
dangerous.
•
Always operate the torch at least 50 cm away from walls
and ceilings and never near flammable materials.
CAUTION: accessible parts of this torch may become very hot during and after use. Handle with care. Keep
young children away from this appliance.
•
Extinguish by turning control knob fully clockwise (OFF). Check that torch is fully
extinguished before leaving unattended.
•
If necessary, the handle can be removed and handle holes on the shell can be cover
by two rubber mounts
•
The handle must keep down when the appliance is working
•
Don't carry the handle when operating, it will be very hot!
All manuals and user guides at all-guides.com
If there is a smell of gas or you suspect a leak once the cartridge
has been fitted, take the appliance to a well-ventilated outdoor
location away from any ignition sources. If you want to check for
leaks in your appliance, do so outside.
Do not try to detect leaks using a flame; use soapy water.
sealing
190 gr gas
cartouche
Lock gas
cartouche
5