IVT EFHC-2000 Mode D'emploi page 9

All manuals and user guides at all-guides.com
INITIAL OPERATION
Always use the correct supply voltage: the power supply
voltage must match the information quoted on the tool
identification plate.
OPERATING INSTRUCTIONS
EFHC-2000; EFHC-3000
EFHC-2000C; EFHC-3000C
∙ Set the thermostat knob (3) to the MAX and let the
machine operate with full power.
∙ The machine will switch on when the switch knob (2)
is set to one of the power settings.
> FAN
> LOW HEAT
> HIGH HEAT
Once the room reaches the required temperature, the
heating element will stop working, but the fan will go on.
Once the temperature decreases, the heating element
will begin to work again. The machine starts and stop
automatically to keep the room temperature constant.
∙ Before turning off the machine, turn the thermostat
knob (3) to OFF position and turn the switch knob (2) to
FAN or 0, let the appliance cool down for two minutes.
> OFF
MAINTENANCE AND STORAGE
Before any work on the device itself,
pull the mains plug.
∙ Always keep the tool and the ventilation slots (if
present) cleaned. Regular cleaning and maintenance
of the appliance will ensure efficiency and prolong the
life of your tool.
∙ If the tool should fail despite the rigorous
manufacturing and testing procedures, the repair
should be carried out by an authorized IVT customer
service.
∙ Keep all nuts, bolts, and screws tight, to be sure
the tool is in safe working condition.
∙ Replace worn or damaged parts for safety.
Use only original spare parts. Parts not produced
∙
by manufacturer may cause poor fit and possible
injury.
∙
and away from any flammable material.
∙
ENVIRONMENTAL PROTECTION
>
[F1]
>
Machine, accessories and packaging should be sorted
[F2]
for environment-friendly recycling.
The plastic components are labelled for categorized
recycling.
These instructions are printed on recycled paper
manufactured without chlorine.
9
Instruction manual
Store the tool in a dry room out of reach of kids
Never wet the device or spray water on it!
Recycle raw materials instead of disposing
as waste.
EN