CAMPARK T20 Manuel D'instructions page 27

All manuals and user guides at all-guides.com
Note:
In the daytime. IR LEDs will not light up. The photos and videos are in color.
At night. IR LEDs will give lights, and the photos and videos are in black and
white.
The Shot lag is 1 minute defaulted. The optional is 5s-60 MIN,
Please set up recording mode and related parameters before entering Live
mode.
When Flash Light is set to "Auto", the camera will adjust the brightness of IR
LEDs automatically in low power. When shooting at night, the brightness will
decrease automatically, and the shooting effect will become a little poor. For
ultra low power, shooting will stop at night.
7. Connection to computer
Please shift Mode to "SETUP", and connect the camera to computer with
USB cable, the camera LCD will show " MSDC prompt This indicates
connecting successfully. And then read or copy the data in SD card to the
computer.
1. Connect the camera to your computer using the USB cable.
2. The camera switches on automatically in the USB mode, irrespective of
the selection on the mode switch.
3. The camera installs itself on the computer as an additional drive under
the name "Removable storage device "
4. Double click on the device to detect the folder "DCIM*
EN
5. The photos and videos are in the sub folders of the "DCIM" folder.
6. You can copy or move photos and video files on the computer.
Alternatively, you can insert the memory card in a card reader on the
computer.
18