Publicité
WARNING:
VERY HOT WHILE IN OPERATION
Never lean over the fire pit while in use. Do not touch
surfaces while the fire pit is in operation. Wait until the
fire pit has completely cooled down after use. Failure
to comply with these instructions may result in serious
bodily injury.
Caution: Do not attempt to operate until you have read and understand all General Safety Information in this
manual and all assembly is complete and leak checks have been performed.
BEFORE TURNING GAS SUPPLY ON
1. Your fire pit was designed and approved for outdoor use only. Do NOT use it inside a building, garage, or
any other enclosed area.
2. Make sure surrounding areas are free of combustible materials, gasoline, and other flammable vapors or
liquids.
3. Ensure that there is no obstruction to air ventilation. Be sure all gas connections are tight and there are no
leaks.
4. Be sure the cylinder cover is clear of debris. Be sure any component removed during assembly or servicing is
replaced and fastened prior to starting.
BEFORE LIGHTING
1. Fire pit should be thoroughly inspected before each use, and by a qualified service person at least annually.
If relighting a hot fire pit, always wait at least 5 minutes.
2. Inspect the hose assembly for evidence of excessive abrasion, cuts, or wear. Suspected areas should be leak
tested. If the hose leaks, it must be replaced prior to operation. Only use the replacement hose assembly
specified by manufacturer. The burner must be replaced prior to the appliance being put into operation if
it is evident that the burner is damaged. The replacement burner should be specified by the manufacturer.
LIGHTING
1. Make sure the control knob is in the "OFF" position.
2. Fully open LP cylinder valve.
Note: For initial start or after any cylinder change, hold the control knob in for 2 minutes to purge air from the gas
lines before proceeding.
3. Push in gas control knob, turn counterclockwise to "LOW", and press the red ignitor button to light the fire
pit. If needed, keep the control knob depressed and continue pressing the red ignitor button until the fire pit
lights (you should hear a clicking sound).
4. After the fire pit lights, release the control knob. To increase the flame, turn the control knob counterclockwise
to "HIGH". To decrease the flame, turn the control knob clockwise to "LOW".
Note: If burner fails to remain lit, all valves should be closed and a waiting period of at least 5 minutes should
pass before attempting to light.
OFF
IGNITOR
IGNITOR
LOW
Figure A
All manuals and user guides at all-guides.com
For outdoor use only. Never use inside a house, or
other unventilated or enclosed area. This fire pit
consumes air (oxygen). To avoid endangering your
life, do not use in an unventilated or enclosed area.
OFF
IGNITOR
Figure B
-10-
DANGER:
CARBON MONOXIDE HAZARD
IGNITOR
LOW
OFF
LOW
Figure C
Publicité
