Sommaire des Matières pour Unova Intermec 6300 Multi Dock
- Page 1 All manuals and user guides at all-guides.com Installation Instructions P/N 962-020-001 Revision A April 1996 Multidock Power Supply 6300 Multi Dock P/N 962-020-001 Revision A *962020001*...
- Page 2 All manuals and user guides at all-guides.com Tools Required 1. Measuring tape and level. 2. Common hand tools. 3. An electric drill, drill bits. 4. Anchor setting tools when installing in concrete. Installation Procedure Summary 1. Install multi dock mounting brackets. 2.
- Page 3 All manuals and user guides at all-guides.com Introduction to Installation General Information Each multi dock will recharge up to four computers, while providing an interface to a LAN or to an RS485 communication system. You can mount several multi docks, side by side or stacked vertically (or both), depending on the number to be installed and the space available.
- Page 4 All manuals and user guides at all-guides.com Horizontal Clearance If RS485 cables will be connected to the multi docks, the holes on mount ing brackets must be at least 21 inches apart, as shown in Figure 1. This will leave approximately 12 inches between multi docks to allow room to connect or disconnect the cables.
- Page 5 All manuals and user guides at all-guides.com Introduction à l’installation Renseignements généraux Chaque station multi accueil peut recharger jusqu'à quatre terminaux PEN*KEY tout en assurant l'interface à un réseau local ou à un système de communication RS485. Il est possible d'installer plusieurs stations multi accueil, soit les unes à...
- Page 6 All manuals and user guides at all-guides.com Hauteur libre La Figure 1 illustre l'espacement minimum et maximum entre les sup ports des stations multi accueil (et non entre les stations elles mêmes). Si les supports sont installés verticalement, les trous inférieurs de chaque support doivent se trouver à...
- Page 7 All manuals and user guides at all-guides.com Connexions finales Station multi-accueil La Figure 3 illustre les connecteurs de la station multi accueil et leurs em placements. Des connecteurs subminiatures D sont utilisés pour la com munication RS485, tandis que des connecteurs téléphoniques à enclenche ment servent aux communications par réseau local (ex: Ethernet).
- Page 8 All manuals and user guides at all-guides.com 15” Minimum Vertical Distance Horizontal 21” Minimum Distance (note: can be reduced to 10-inches when using LAN communication) Figure 1 Minimum Clearances for Mounting Bracket...
- Page 9 All manuals and user guides at all-guides.com Mounting Hole Vertical Spacing ” Mounting Holes 16” on-center Use four 1/4-inch screws or bolts (lag screw shown for use in stud wall) Keyhole Cut-outs Hang multi dock on these when bracket is secure. Figure 2 Mounting Bracket Detail...
- Page 10 All manuals and user guides at all-guides.com Connectors DC Power Connector RS485 Connector (one on each end of multi dock) Connector Figure 3 Multi Dock Connectors (bottom view)
- Page 11 All manuals and user guides at all-guides.com ” 4.9” ” ” 2.0” Mounting Holes 2-inch vertical spacing 2-3/4 inch horizontal spacing Figure 4 Power Supply Wall Bracket (NPN: 699-894-002)
- Page 12 All manuals and user guides at all-guides.com...