Orbegozo CR 5036 Manuel D'instructions page 13

4. Do not use the heater on extremely deep-pile carpets!
5. Do not use the heater in an upright position.
GENERAL DESCRIPTION
INSTRUCTIONS FOR USE
The selector switch and the thermostat knob enable you to select the following functions:
Selector switch:
: OFF. Both the fan and the two heating elements are switched off
: "Cool air". Only the fan is switched on
: "Warm air for gradual heating-up. ECO position (900 W): the fan andone of the heating
leements are switched on.
: "Hot air" for quick heating-up. Full power (1800 W): the fan and the two heating elements are
switched on.
Thermostat knob:
With the thermostat knob you can set a constant room temperature. When the selector switch is set to
position I or position II the heater will automatically switch on as soon as the room temperature falls
below the set temperature.
As soon as the set temperature falls is reached, the switch will turn off.
Rotate the knob clockwise to obtain a higher temperature setting or anti-clockwise for a lower
temperature setting.
You may adjust the thermostat during use.
Oscillation
With the rocker switch you can switch on or off the oscillation of the fan heater. The oscillation
function can be operated to every function separately.
Control lamp:
thermostat switch.
All manuals and user guides at all-guides.com
A. Air inlet grille
B. Air outlet grille
C. Selector switch
D. Thermostat knob
E. Control lamp
F. Oscillation
ep ( ) is turned on in combination with the
13