FORM FIT HD 6L11 Instructions D'installation page 2

Illustration #2 – Pedestal Location and Alignment
Illustration #3 – Protector Install
Illustration #4 – Clip Configuration – Patent No. 6,892,427
Step #10
10. Peel and fold an anti-abrasion film pad in half over the edge of the hood underneath each of the two (2) inner holes in the protector. See
Illustrations #1 & #4 – Step #10
11. a) Place a clip over each of the anti-abrasion film pads on the edge of the hood as shown below in Illustration #4 – Step #11a.
b) Insert a pin through the protector into each of the clips, See Illustration #4 – Step #11b.
c) Insert a #6 x 5/8'' screw through an 'L'- bracket and into the clip. See Illustration #4 – Step #11c & 11d.
d) Make sure all the components are well seated together; the protector is centered on the hood, and then tighten the screws into the clips.
12. Repeat steps #10 and #11 for the other two (2) holes.
13. On some vehicles it may be necessary to adjust the hood bumpers and/or latch for proper clearance.
Note: Do not pull on the protector when opening or closing the hood.
CARE INSTRUCTIONS
Clean the protector with a mild soap and water solution or plastic cleaner only. Do not use chemicals or
solvents. Periodically check to make sure the bumpons are in place and the protector is secure. Avoid using
automatic car washes. Do not pull on protector when opening or closing the hood.
Thank you for purchasing a form fit hood protector. Retain this sheet for care instructions and kit information.
Made in Canada
All manuals and user guides at all-guides.com
Hood
Pedestal
Fingers
(Sit against the trailing
edge of the molding)
Molding
Step #11a Step #11b
Step #11c & 11d
Rev0.110628