Publicité
Please read these instructions carefully before starting the installation.
- Remove all packaging and check the product for missing parts and damages before starting the installation.
- We strongly recommend a qualified and registered installer.
- The range of recommended water pressure is 0.08 MPa - 0.8 MPa. Use the equipment within specified water pressure.
- The water supply temperature must be between 10 - 30 ° C. Make sure the water temperature is within this range.
- Please don´t use other than the components supplied which are included with the product (hose, shut off valve, etc.).
________________________________________________________________________________________________
Lea atentamente estas instrucciones antes de comenzar la instalación.
- Compruebe el producto por si faltasen piezas o estuviesen dañadas.
- Le recomendamos la instalación por parte de personal cualificado.
- El rango de presión de agua recomendable es de 0,08 MPa - 0,8 MPa. Utilizar el equipo dentro de la presión de agua indicada.
- La temperatura del suministro de agua debe estar entre 2 - 45ºC. Asegúrese de que la temperatura del agua se encuentra dentro de este
rango.
- No utilizar otro tipo de suministro de agua distinto al que se incluye con el producto (flexible, llave de paso, etc.).
________________________________________________________________________________________________
Lire attentivement ces instructions avant de commencer l'installation.
- Vérifier le produit au cas où il manque une pièce ou qu'il soit abîmé.
- L'installation doit être réalisée par du personnel qualifié.
- La pression recommandée doit être entre 0,08Mpa et 0,8 MPa. Utiliser le produit sous cette pression recommandée.
- La température d'alimentation en eau doit être entre 10 et 30ºC. Vérifier que la température soit correcte.
- Ne pas utiliser un autre système d'alimentation en eau que celui qui se trouve avec le produit (flexible, robinet d'arrêt, etc...).
-lntegrated design
lntegrated design combining fill valve and flush valve, easy installation, concise and aesthetic appearance.
-Touchless Flush
No touch induction flush, flush just after waving your hand, prevent bacterial infection, easy to use.
-Back-up mechanical push button
lt can be used when the battery is dead or electronically faulty with mechanical push buttons; And it is also hydraulic drive flushing, short button travel, light
press .
-Energy Saving
Low power consumption: 3pcs 1.5 V ''AM'' size alkaline batteries can be used for sensor module for 8 to 1 O months and 4pcs 1.5V.
"AA" alkaline batteries can be used for control module for 1 year based on 3000 cycles per month (Laboratory data, actual time varies slightly indifferent
environments ).
-Water Saving
Patented delayed filling design to save water consumption.
-Wide water pressure application range
lt can work normally under the dynamic pressure of 0.07Mpa to static pressure of 0.8Mpa with stable water consumption.
-Convenient water level adjustment
By adjusting valve body and shut-off cup height to adjust water level, applicable for a wide range of different tanks.
-Anti-syphon function
Prevent water from returning to the water supply system and prevent the water supply system from being contaminated.
-Fast drainage and strong flushing effect
With a 3" base, the drainage speed is about 4L/S in a 0.7L/cm standard water tank. (Optional 2" base).
-Stable and reliable
lt adopts advanced production technology to reliably seal the control circuit. The plug-in adopts waterproof connectors to ensure long-term stable and
reliable operation.
-Easy maintenance
lt adopts easy-to-clean built-in filter to block dirty water from entering the inlet valve, and the filter is detachable, easy to operate and easy to clean.
2
Publicité
