Memory Card; Installing The Battery - LOGICOM L-195 Manuel D'utilisation

1.6.3 Memory card

Insert the card into the memory card reader and gently press on the card in order to insert it correctly.
Tip: If the memory card does not work, check that it is inserted correctly and also check the metal contact
points.
1.7 Battery

1.7.1 Installing the battery

 Remove the back cover from the phone.
 Place the end of the battery that has the metal contacts against the battery connector.
 Gently push the battery down and press on the other end of it to snap it in.
Tip: Do not force the battery connector as it can be damaged.
Keep the battery away from any source of flame. Follow local laws as well as regulations for disposing of used batteries.
Check the serial number of the charger before charging the mobile phone.
Use only a battery, charger and accessories that have been approved for use with this phone model. The use of other types of batteries, chargers
and accessories may invalidate certification and or warranty conditions for the equipment and may be dangerous.
Return the waste and used batteries to the supplier or a recycling site.
WARNING:
The battery may explode if you replace it with a model that is not compatible.
Dispose of used batteries according to the instructions.
1.7.2 Charging
Connect the charger to the port provided for this purpose and located under the phone.
After connecting the charger, the battery strength indicator located in the upper right-corner of the screen
scrolls, showing that the phone is charging. When the indicator is full and the scrolling stops, the battery is
charged. Disconnect the charger.
When the level of charge is insufficient, a warning message is displayed, and the charge indicator appears
empty. When the battery level gets too low, the phone turns off automatically. Do not leave the battery at a low
22