Maktec MT191 Manuel D'instructions page 5

ENGLISH (Original instructions)
1. Pointer
2. Knob
3. Switch trigger
4. Lock button or Lock-off button
5. Planer blade
6. Rear base
7. Foot
8. Socket wrench
9. Bolts
10. Drum
11. Drum cover
12. Adjusting plate
13. Inside edge of gauge plate
14. Blade edge
SPECIFICATIONS
Planing width
Planing depth
Shiplapping depth
No load speed (min
Overall length
Net weight
Safety class
• Due to our continuing programme of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for planing wood.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
PLANER SAFETY WARNINGS
1. Wait for the cutter to stop before setting the tool
down. An exposed cutter may engage the surface
leading to possible loss of control and serious injury.
All manuals and user guides at all-guides.com
Explanation of general view
15. Screws
16. Heel
17. Back side of gauge base
18. Gauge plate
19. Gauge base
20. Planer blade locating lugs
21. Heel of adjusting plate
22. Set plate
23. Inside flank of gauge plate
24. Mini planer blade
25. Groove
26. Start
27. End
28. Cutting line
Model
-1
)
ENE001-1
ENF002-2
GEA010-1
GEB010-4
29. Screw
30. Edge fence (Accessory)
31. Sharpening holder
32. Wing nut
33. Blade (A)
34. Blade (B)
35. Side (D)
36. Side (C)
37. Limit mark
38. Chip cover or Nozzle
39. Screwdriver
40. Brush holder cap
MT191
82 mm
2 mm
9 mm
16,000
285 mm
2.7 kg
2. Hold the power tool by insulated gripping surfaces
only, because the cutter may contact its own cord.
Cutting a "live" wire may make exposed metal parts of
the power tool "live" and could give the operator an
electric shock.
3. Use clamps or another practical way to secure and
support the workpiece to a stable platform. Holding
the work by hand or against your body leaves it
unstable and may lead to loss of control.
4. Rags, cloth, cord, string and the like should never
be left around the work area.
5. Avoid cutting nails. Inspect for and remove all
nails from the workpiece before operation.
6. Use only sharp blades. Handle the blades very
carefully.
7. Be sure the blade installation bolts are securely
tightened before operation.
8. Hold the tool firmly with both hands.
9. Keep hands away from rotating parts.
10. Before using the tool on an actual workpiece, let it
run for a while. Watch for vibration or wobbling
that could indicate poor installation or a poorly
balanced blade.
11. Make sure the blade is not contacting the
workpiece before the switch is turned on.
12. Wait until the blade attains full speed before
cutting.
/II
5