Publicité
Les langues disponibles
Les langues disponibles
RADIO – CHANNELS
ABOUT RADIO CHANNELS
The NWR radio channels work in the same way as a
regular radio channel. All of the NWR transmission
stations operate on 1 of 7 frequencies.
CHANNEL
CORRESPONDING RADIO FREQUENCY
1
2
3
4
5
6
7
A
Auto – the unit will tune to the strongest
RF signal available
The unit labels each frequency as a channel (1-7 or
Auto). Once the radio frequency for a region has been
selected the unit will receive voice and code information
from that station.
The channel number in use
can be viewed on the top left-
hand corner of the LCD.
SETTING THE RADIO CHANNEL
To change the radio channel, navigate to "Set Channel"
setting mode and select the desired Channel, as shown
in the Changing Settings section.
WRB308 M_EN_V6.P65
All manuals and user guides at all-guides.com
162.400 MHz
162.425 MHz
162.450 MHz
162.475 MHz
162.500 MHz
162.525 MHz
162.550 MHz
18
RADIO – LOCATIONS
SETTING THE LOCATION
You need to set the location so that you can receive
weather and environmental information for an area that
is relevant to you.
You can choose the location by either the state and
county name, or FIPS code. Up to 9 locations (1-9) can
be stored.
NOTE If you do not set a location, the radio will use the
default setting "CO:All" for all counties.
To set the location:
1.
Navigate to "Set Location" setting mode as shown
in the Changing Settings section.
2.
Select where you want to store the location e.g.
C1.
3.
Select the 6-digit number e.g. "000000". ("----"
means the location is disabled.)
4.
Select "Name" or "FIPS".
•
If you select "Name" you can select first the State
and then the County of your chosen location, then
press EXIT. (If you wish to receive State-wide
NOAA messages, press EXIT once you have
selected the State.)
•
If you select "FIPS" you need to enter the 6-digit
18
2005.5.30, 9:49
Publicité
