English
1. Parts list.
2. Insert A-A31R at the end of part A-A11, then connect A-A11 to A-A7 and A-A13.
3. Note: Do not tighten the nut now.
4. Note: Do not tighten the nut now.
5. Slide the two buttons in the grooves of parts A-A8L and A-A8R.
6. insert the end of A-A8R to the bolt, turn the bolt to insert in the groove then tighten the nut.
7. Connect and fix A-A15 to A-A11 on the triangular part A-A30 with the bolt and the nut.
8. Insert the end of part A-A9 into the bolt, turn the bolt to insert in the groove then tighten the nut.
9. Slide the bolt in the groove of part A-A23. Then use another bolt to connect A-A23 to A-A29.
10. Note: Do not tighten the nut now.
11. Install the plastic part A-A32 in the direction shown on the picture.
12. Slide A-A24 in the groove of the A-A18.
13. Adjust A-A28 in the appropriate position then tighten with the bolt and the nut.
14. Insert polycarbonate panel A-A40.
15. SILICONE SEALANT
16. GLUE GUN
17. NOTE: Silicone sealant and glue gun are not included and must be purchased locally.
18. Tip: glue parts A-A9 & A-A10 carefully. Install the polycarbonate panels in the correct position.
19. Fix part A-A32 which is located at the bottom of the door, in part A-A6.
20. Profile A-A22 pass through the A-A32 which on the top of door, then adjust it to the middle
position.
21. Use the "W" clip to fix the PC sheet with the profile as shown.Make one end of clip into the
gloove and make it support to the profile, then force the other end make the clip tensional, put the
other end into the groove.
22. Rear
23. Front
24. Note :
25. Remove approximately 2 inches of film from all sheet edges before installing. remove all film
immediately after the constructions completed.
26. The UV-protected side of the sheet is covered with opal white film and must face towards the
sun.
27. Two sides of PC sheet are covered with thin film, one side's film is transparent, another side's
film is opal white.The UV-protected side of the sheet is covered with opal white film and must face
towards the sun.