SGL Jolly Mode D'emploi Et Entretien page 27

The setting sequence is the following:
1st Pressure
+3
Red LED on
To exit the temperature setting mode, switch the machine off
then on again.
To enter the dose self-learning mode, switch the machine on
and wait until it reaches the heating temperature, and then:
• Press the short coffee dispensing button ➌ and keep it
pressed for 3 seconds (continuous pressure) (the ma-
chine emits a "beep" sound);
• Release the button when the blue LED starts blinking;
• Touch the coffee button you want to set (short ➌ or long
❹) The machine starts delivering (red flashing LED).
Upon reaching the desired dose in the cup, press the but-
ton again;
• The machine ends the dispensing and the new dose is
memorized;
• It is possible to set the new dose immediately through the
same button or another available one;
• Switch off the machine, then on again to return to normal
operating mode.
2nd Pressure
Standard
Blue and Red LEDs on
DOSE SELF-LEARNING
3rd Pressure
Blue LED on
MANUAL
version
MANUAL
version
EN
-3
18
19
20
27