Ener-G+ LT3050CL Guide De L'utilisateur page 13

6.4 AC ELECTRIC CONNECTING
sTEp 1
Starting the generator.
sTEp 3
Turn on the BREAKER or push down the AC protector.
6.5 DC APPLICATION
the Dc terminal may be used for charging 12V automotive-type batteries only.
1) When using automotive-type batteries with battery cables, be sure to disconnect the minus
pole battery cable from the battery before charging.
2) Connect the charging cable to the battery terminals and the DC terminal of the generator.
• C
onneCt the positive battery terminal to the positive generator terminal
• D
o not reverse the Charging Cables
.
battery may oCCur
• D
o not allow the free enDs of the Cable to touCh eaCh other
CirCuit that will Damage the battery
• w
hen a large CapaCity battery is ChargeD
),
the discharged condition
3) Batteries produce explosive gases, keep sparks, flames and cigarettes well away.
4) To prevent the possibility of creating a spark near the battery, always connect the charging
cables to the battery first and only then to the generator. When disconnecting, you should
disconnect the cables of the generator first.
5) Charge the battery in a well ventilated place.
6) Before charging the battery, check its temperature first. Remove the cap from each battery
cell. Do not charge if the electrolyte temperature exceeds 45 degrees Celcius.
02m1_User_guide_GENERATOR_EBI10869.indd 13
All manuals and user guides at all-guides.com
6. ac & Dc aPPlication
sTEp 2
,
or serious Damage to the generator anD
.
,
exCessive Current flows
DC .
anD the fuse will burn out
i n s t r U c t i o n M a n U a l
Connecting the appliances.
.
/
or
, ,
if this oCCurs there will be a short
(
the value varies depending on
www.EnErgplus.com P a g e 1 3
4/8/08 11:12:06 AM