All-Power APG3304 Mode D'emploi page 16

9000W Generator
Assembly
Unpacking
1. Remove the generator and loose parts box from the carton.
2. Compare the loose parts with the inventory list below.
Wheel Assembly
Perform the following tasks to install the heavy-duty wheels onto the generator assembly.
1. Insert axle through brackets located on frame at the bottom of generator.
2. Center axle in frame and place each wheel over each end of the axle. Then insert axle end
into the hole in the center of the wheel hub.
3. Place each large washer over the axle ends and insert axle through center of washer until
washer is fully seated against wheel hub.
4. Insert straight side of cotter pin into hole at end of the axle rod and thread the cotter pin
through the hole until pin snaps into place.
5. Repeat using the second cotter pin on the opposite end of the axle to secure the opposite
wheel to the axle assembly.
All manuals and user guides at all-guides.com
Description
1. Wheel Axle
2. Heavy Duty Wheels
3. Large Washers
4. Cotter Pins
5. Front Stand-Off Support V-Leg
6. Support V-Leg Mounting Screws 2
7. Handle
8. Handle Mounting Bracket
9. Mounting Bracket Back Plate
10. Hinge Bolt Mounting Nuts
11. Three Inch Mounting Bolts
QTY.
1
2
4
2
1
1
1
1
3
3
16