Testboy TB-3000 Mode D'emploi page 31

You must use the '10 A' socket when measuring currents above
250 mA.
Using the test probes, touch the test points of the test object. The multimeter
automatically searches for the most suitable measurement range. Read
measurement value on the display.
To protect against overheating, measurements should not be taken
for more than 30 seconds. Following this the device should be
allowed to cool down for at least 30 minutes.
Alternating current
Range
200 µA
2000 µA
20 mA
200 mA
2 A
10 A*
Overload protection: F 250 mA / 690 V fuse protection for µA and mA
ranges.
10 A range is protected by F10 A / 690 V.
* On 10A-range pay attention to maximum ON/OFF time!
To protect against overheating, measurements should not be taken
for more than 30 seconds. Following this the device should be
allowed to cool down for at least 30 minutes.
®
Testboy TB-3000
Resolution
0.1 µA
1 µA
0.01 mA
0.1 mA
10 mA
0.01 A
Operation
Accuracy
± 1.3% of rdg. + 5 digits
± 1.5% of rdg. + 8 digits
31