Publicité
Les langues disponibles
Les langues disponibles
STEP 7
Insert the (4) threaded spindle rods into the
holes at each of the four corners of the gate.
NOTE:
Once the spring loaded mounting pin is
inserted into the gate door hole, it cannot be
taken out again by hand.
NOTE:
It may be necessary to hold the
threaded spindle rods or rubber feet while
rotating the adjustment wheels to ensure the
entire unit does not rotate.
Operating the Door Latch
STEP 1
Use your thumb or forefinger to pull back on the thumb lock. This action will release
the locking pin below the metal saddle that joins the door and the gate frame.
NOTE:
If your latch is not properly engaging, ensure that your gate is level,
mounted properly, and that you have not over-tightened the threaded spindle rods
All manuals and user guides at all-guides.com
STEP 8
Position the gate so that it is level and centered
within your doorway or opening. Rotate the
adjustment wheels on the threaded spindle
rods in the opposite direction as in Step 6,
expanding the gap between the rubber foot and
the adjustment wheel. Expand each of the (4)
threaded spindle rods until they make contact
with the doorway or opening. Do not fully
tighten the threaded spindle rods yet.
NOTE:
The gap between the gate and wall
should not exceed more than 2.5 inches. Make
the appropriate adjustment to ensure you have
installed your gate safely.
THUMB LOCK
STEP 9
When you are satisfied with the general placement
of your gate, fully tighten the threaded spindle
rods attached to the lower corners of the gate by
further rotating the adjustment wheels. Continue
by tightening the upper threaded spindle rods. As
you tighten the upper threaded spindle rods, you
will notice the gap between the door frame and the
door begin to narrow. In order for the gate to
function properly, tighten the upper threaded
spindle rods completely without removing the
plastic lock spacer. Then, pull the thumb lock back
to remove the plastic lock spacer. This will ensure
proper spacing between the door and frame.
NOTE:
each of the (4) threaded spindle rods. Make the
appropriate adjustment to ensure you have
installed your gate safely.
STEP 2
With the thumb lock pulled back, lift up on the entire door panel,
raising the gate high enough for the upper and lower metal saddles
to clear free of their counterparts. Your gate door should now be
free to fully open. To close the gate, simply repeat Steps 1 – 2 in
reverse.
.
DOOR
THUMB LOCK
PLASTIC LOCK
SPACER
FRAME
There should be equal spacing among
Publicité
