Adjusting The Speed - Campbell Hausfeld TL146200AJ Manuel De L'opérateur

Operating Instructions
Preparation
(Continued)
rotatIng front head
1. Disconnect your multi-function
oscillating tool from air supply.
Remove any accessories from arbor.
2. While holding tool with one hand,
use your thumb to pull back the
locking trigger. With other hand
rotate the front head. Use the
alignment arrows on tool to center
with locking pin. See Figure 5.
3. If trigger does not lock into place,
let go of trigger and rotate head
left and right till it clicks into
place. Head will rotate 360° in 45°
increments.
Tool can be set to left or right handed
users for any orientation or set-up. This
will allow you to set your tool to the most
comfortable set-up for the hard to reach
and awkward positions.

adjustIng the sPeed

Disconnect your multi-function oscillating
tool from air supply. Hold tool with one
hand and grab the speed controller collar
with other hand. See Figure 6. Rotate
collar to desired speed setting. The
speed controller collar should securely
index at each setting.
Setting Speed opm (Approximate)
1
2
3
4
8
10,000
12,500
13,500
14,500
www.campbellhausfeld.com
Front Head
Figure 5 - Rotate Front head
Speed
Adjustment
Ring
Figure 6- Adjust the Speed
Rotating Head
Release
Body