Publicité
Les langues disponibles
Les langues disponibles
V1.0
4.
Make sure the angle gauge (B) is set to the desired angle and that
the workpiece is flush.
5.
Hold the workpiece steady with one of your feet.
6.
Depress the handle fully to lower the blade and complete the cut.
7.
Slowly raise the handle to lift the blade.
7.1 Do not release the handle while depressed. This will cause the
handle to slam upwards and may damage the tool.
8.
Remove the workpiece from the opening.
CUTTING GUIDE
This tool cuts a wide variety of products up to a maximum width of 9 in.
It includes a miter guide for angled cuts from 0 to 45°.
Use this guide for recommended products and thicknesses.
MATERIAL
Fibre cement siding
LVP, LVT, SPC and WPC
Laminate flooring
Engineered wood flooring
Vinyl siding
Vinyl tile (VCT)
MDF and soft plastic
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient,
easier to control and will have fewer problems.
2.
Inspect the tool components periodically. Repair or replace
damaged or worn components. Only use identical replacement parts
when servicing.
3.
Follow instructions for lubricating and changing accessories.
4.
Only use accessories intended for use with this tool.
5.
Keep the tool clean, dry and free from oil/grease at all times.
Visit www.princessauto.com for more information
9 in. Laminate Floor Cutter
MAX. CUTTING THICKNESS
5/16 in. (8 mm)
5/16 in. (8 mm)
15/32 in. (12 mm)
15/32 in. (12 mm)
15/32 in. (12 mm)
19/32 in. (15 mm)
19/32 in. (15 mm)
9113911
7
Publicité
