Outdoor Essentials ProSeries Instructions D'assemblage

ProSeries
46½" W
Digging post holes
With a posthole digger or power auger, create each hole between
12" and 16" wide and a minimum of 36" deep or to the frost line.
We recommend using a treated 4x4 wood post to reach the frost
line and provide extra support for the gate. Then, backfi ll the holes
with 6" of gravel to allow drainage from the bottom of the posts
(fi g. 1). Make sure to distribute the gravel evenly in both holes.
The gate can be set up left swing or right swing. Consider the
swing direction when determining which post will be your hinge
post.
Mix concrete in the post hole per the instructions on the bag.
Install the post into the hole and tap it to the proper depth. Use
a level to ensure post is plumb. Brace the post with temporary
supports as the concrete sets. Repeat for second hole.
©2023 UFP Retail Solutions, LLC. All rights reserved. Outdoor Essentials is a registered trademark of UFP Industries, Inc.
WOODBRIDGE PRIVACY GATE KIT
ASSEMBLY INSTRUCTIONS
4x4 - 45-1/4" H 4x4 - 45-1/4" H
4x5 - 56-5/8" H 4x5 - 56-5/8" H
4x6 - 69-5/8" H 4x6 - 69-5/8" H
2801 East Beltline NE, Grand Rapids, MI 49525 | (844) 529-5882
OutdoorEssentialProducts.com
Kit contents
• 2 – Gate Jambs with covers
• 2 – Top/Bottom rails
• 2 – Gate jambs with covers
Items you may need
• Power drill with 1/8" and
1/4" drill bits
• 7/16" wrench
• Tape measure
Preparation
Check local ordinances and regulations before building your
fence. Before construction, contact your local utility companies
to mark any underground cables and pipelines. In addition, it is
a good idea to discuss plans with any neighbors along your
proposed fence line.
Gate opening
• 7 – Pickets
• Hardware kit
• Pencil
• Safety glasses
• 4x4 treated wood post
• Blocks or clamp
Step 3
47-3/4"
12"-16"
diameter
hole
Vinyl Post
Concrete
36" to
frost line Structural
support post
Gravel
14610_3/23
fi g. 1
PG. 1