Publicité
Les langues disponibles
Les langues disponibles
PARTS
A. Top cover
G. Cycle Indicator
Lights
B. Main cover
H. Removable Tray
C. Upper Tray
I. Tongs
D. Heating Plate (inside)
J. Measuring Cup
E. ON/OFF Button
F. Cycle Start Button
TO USE
1
Before running this appliance, it is important that all bottles, bottle parts
and/or other accessories are clean. They must be washed, rinsed and empty.
2
Position the appliance on a flat surface and out of reach of children where it
cannot be knocked or moved during operation. Remove the tray.
3
Remove the measuring cup and tongs from the unit.
4
Fill the measuring cup to the FILL LINE (3 oz/80 mL) with DISTILLED WATER and
pour the water ONTO THE HEATING PLATE.
Note: For best performance, use recommended water and descale monthly.
Water with minerals may shorten the life of this appliance.
CAUTION: DO NOT EXCEED the recommended amount of water.
If it is necessary to drain water from the base, always POUR AWAY
FROM YOU.
5
Place the removable tray (part H) in the sterilizer heating chamber. Arrange the
bottles and other parts in the tray.
Note: If using Dr. Brown's bottles and parts, see Figure A through Figure G
on the next page for suggested layout options. Both narrow and wide-neck bottles
are shown.
6
Close the main cover (part B) and arrange the parts on the upper tray (part C) as
shown in Figure C and Figure G.
Note: This appliance can sterilize any item that can withstand boiling water,
such as pacifiers/soothers, teethers, toys and utensils.
7
Close top cover (part A).
8
Plug the power cord into an electrical outlet and press the On Button (E).
Note: When the sterilizer is turned on, you will notice that cycle indicator lights (G)
will illuminate with a cycle of RED-BLUE-GREEN colors. After this initial cycle-through
of colors, the green symbol will remain lit indicating "READY" mode.
3
A
C
B
G
E
F
D
H
J
I
Ready Cycle: With the green "ready" symbol illuminated, press the cycle
start button (F).
Heat Cycle: The red symbol will indicate that the appliance is "HEATING"
to create steam. It will remain lit until all water is consumed and the
sterilization cycle is complete. This is approximately 8 minutes but may
vary by the amount of water you add, the number of items to be
sterilized and other environmental factors.
Cool Down Cycle: Upon the completion of the sterilization cycle, the
blue symbol will illuminate to indicate the "COOL DOWN" cycle. Note:
If you forget to add water to the unit and start the heating cycle (red light
on), the unit must complete the cool down cycle (blue light on) before a
new "heat" cycle can be attempted.
READY (unload) Cycle: When the cool down cycle is complete, the
green "READY" symbol will again light. You may unload your items or
allow them to air dry.
WARNING: DO NOT open lid or reach over the appliance while in use,
as steam will cause burns and serious injuries. DO NOT touch
hot surfaces, including top cover, main cover and trays, during or
immediately after use.
9
Open the main cover and remove all bottles and place on a countertop or other
flat surface. Open the top cover and re-assemble the bottles with the various
components.
CAUTION: After sterilizing, wait 10 minutes for parts to cool, then
open top cover carefully and beware of residual steam. Be careful to
avoid spilling or splashing water on yourself when removing contents.
10
You may now turn the unit off by pressing the on-off button (E) or begin another
sterilization cycle after again adding 3 oz/80 mL of water.
4
Publicité
